Create a James Webb space pumpkin
Create your own James Webb Space Pumpkin using the instructions below. Happy Halloween!
Difficulty level: 1
You will need
- A pumpkin
- The James Webb Space Pumpkin stencil (PDF below)
- A sharp knife
- A spoon
- Push-pin or small sharp object
- A small light or candle
How to make your James Webb Space Pumpkin
- Print the stencil.
- Carefully cut a hole in the top of the pumpkin to create the lid. Be sure to angle your blade inward to create a ledge for the lid.
- Scoop out the seeds and strings with a spoon. Scrape the flesh from the inside of the pumpkin until it is about 2.5 to 4 cm thick where you would like to carve. Scrape the bottom until it is smooth so that it will keep a light level.
- Trim excess paper, leaving a 1-cm border around the pattern. Fold along crease lines if necessary and tape onto the pumpkin.
- Poke holes through the pattern along the dotted lines using a push pin or a small sharp object. Remove the paper once the pattern is fully transferred onto the pumpkin.
- Carve dot to dot, while keeping the blade at a 90° angle and being careful not to apply too much pressure to the pumpkin. To change direction, remove the blade and then reinsert it. Push the cut pieces out gently from the inside out. It is recommended to start with the smallest pieces first and work from the centre outwards.
- Place light inside and put the lid back on.
Tag the Canadian Space Agency (@CanadianSpaceAgency) in your Webb pumpkin photos on Instagram and we might just share them.
With NASA's authorization. Stencils created by Leah Hustak.
- Date modified: